Download DSMC Power Operation Guide
Transcript
R E D D S M C P O W E R O P E R AT I O N G U I D E RED BRICK CHARGER RED BRICK Charger The RED BRICK Charger offers rechargeable support for RED BRICK (153 Wh) lithium-ion batteries. The RED BRICK Charger provides up to 4 A in constant current mode. The RED BRICK Charger charges two (2) attached RED BRICK batteries sequentially in approximately six (6) to eight (8) hours. The RED BRICK Charger can charge one (1) fully discharged RED BRICK in approximately three (3) hours. The RED BRICK Charger also serves as a power supply using the 6-pin LEMO ® auxiliary output port. WARNING: DO NOT exceed 100 W power draw from the 6-pin LEMO auxiliary output port. NOTE: The RED BRICK Charger stops charging automatically if battery temperature exceeds 40˚C (104˚F), or drops below 0°C (32°F). PREPARE THE RED BRICK CHARGER When the RED BRICK Charger is brand new, it may be difficult to connect and disconnect the V-plate adaptor on the RED BRICK. RED recommends that you perform a break-in sequence with a new RED BRICK Charger. Before charging a RED BRICK in the charger, fully engage and then disengage the RED BRICK approximately 20 times. COPYRIGHT © 2015 RED.COM, INC 955-0038, REV-H | 44