Download DSMC Power Operation Guide
Transcript
R E D D S M C P O W E R O P E R AT I O N G U I D E 5. Apply pressure and tighten the four (4) captive screws in a cross pattern (“X” pattern) approximately two (2) turns each using a T20 Torx driver. DO NOT FULLY TIGHTEN. Install screws 6. Fully tighten the four (4) screws in a cross pattern (“X” pattern). WARNING: DO NOT OVERTIGHTEN. REMOVE THE +1 ADAPTOR MODULE REQUIRED TOOL: T20 Torx driver 1. Turn off the BRAIN. 2. Loosen the four (4) captive mounting screws in a cross pattern (“X” pattern) using a T20 Torx driver. 3. Disconnect the HDMI connector from the BRAIN. 4. Remove the +1 Adaptor Module from the BRAIN. COPYRIGHT © 2015 RED.COM, INC 955-0038, REV-H | 22