Download GRLIB IP Core User`s Manual
Transcript
COBHAM GAISLER 793 GRIP 66.2.4 Interrupt broadcasting The Broadcast Register is activated when the generic ncpu is > 1. An incoming irq that has its bit set in the Broadcast Register is propagated to the force register of all CPUs instead of to the Pending Register. This can be used to implement a timer that fires to all CPUs with that same irq. 66.2.5 Interrupt (re)map functionality The interrupt controller can optionally be implemented (as an alternative to the two-interrupt levels scheme) with functionality to allow dynamic remapping between bus interrupt lines and interrupt controller interrupt lines. If the design includes this functionality then switch-logic will be placed on the incoming interrupt vector from the AMBA bus before the IRQ pending register. The Interrupt map registers will be available starting at offset 0x300 from the interrupt controller's base address. The interrupt map registers contain one field for each bus interrupt line in the system. The value within this field determines to which interrupt controller line the bus interrupt line is connected. In case several bus interrupt lines are mapped to the same controller interrupt line (several fields in the Interrupt map registers have the same value) then the bus interrupt lines will be OR:ed together. Note that if bus interrupt line X is remapped to controller interrupt line Y then bit Y of the pending register will be set when a peripheral asserts interrupt X. Remapping interrupt lines via the Interrupt map registers has the same effect as changing the interrupt assignments in the RTL code. 66.3 Registers The core is controlled through registers mapped into APB address space. The number of implemented registers depends on the number of processor in the multiprocessor system. Table 1034.Interrupt Controller registers APB address offset Register 0x00 Interrupt level register 0x04 Interrupt pending register 0x08 Interrupt force register (NCPU = 0) 0x0C Interrupt clear register 0x10 Multiprocessor status register 0x14 Broadcast register 0x40 Processor interrupt mask register 0x44 Processor 1 interrupt mask register 0x40 + 4 * n Processor n interrupt mask register 0x80 Processor interrupt force register 0x84 Processor 1 interrupt force register 0x80 + 4 * n Processor n interrupt force register 0xC0 Processor extended interrupt acknowledge register 0xC4 Processor 1 extended interrupt acknowledge register 0xC0 + 4 * n Processor n extended interrupt acknowledge register 0x300 + 0x4 * n Interrupt map register n Table 1035. Interrupt Level Register 31 16 15 RESERVED 31:16 Reserved 1 IL[15:1] 0 R
Related documents
LEON3 User`s Manual
GRLIB IP Core User`s Manual
GRLIB IP Core User`s Manual
LEON3 GR-XC3S-1500 Template Design
University of Stuttgart Diploma Thesis Design of a Memory
GAISLER
Portable Paper
USER MANUAL
LEON/GRLIB Configuration and Development Guide
UT700 LEAP VxWorks 6.7 BSP Manual
GRLIB IP Core User's Manual
GAISLER