1
Download User Guide - GarrettCom
Transcript
BASE CONFIGURATION 1 DYNASTAR 100/100i Introduction The DYNASTAR 100/100i hardware consists of a D YNASTAR 100 baseboard installed in a stand-alone chassis. The baseboard has a 25 MHz Motorola 68360 RISC-based processor, 1 Mbyte of RAM (expandable to 16 MB), 2 Mbytes of flash EPROM, a 4 Mbyte SIMM, and 128 kbytes of PROM. Configuration information is written into flash EEPROM. The DYNASTAR 100 base configuration consists of: • One Ethernet LAN port • Two high-speedWAN ports (V.35 or X.21) • One synchronous/asynchronous port (V.24/RS-232) • One asynchronous console port for configuration and diagnostics (V.24/RS-232) The DYNASTAR 100i base configuration provides: • One ISDN BRI interface (2B + D) • One Ethernet LAN port • One high-speed WAN port (V.35 or X.21 or V.24/RS-232) • One asynchronous console port for configuration and diagnostics (V.24/RS-232) Expansion slots on both the DYNASTAR 100 and the D YNASTAR 100i provide the capability to support an additional LAN port or multiple WAN or async ports. Figure 1-1 and Figure 1-2 show the base configuration of the D YNASTAR 100 and DYNASTAR 100i back panels. For more detailed information on hardware and installation, see Chapter 2, DYNASTAR Installation. 1-3
