Download SPEED4/4+ User Guide

Additional card warning messages
If you install more than one SPEED host card, or install additional cards at a later date, the
following warning messages will be displayed during system start-up.
Note
Display of these messages and update of Speed Node and Init files only occurs
once after installation of additional cards. This takes place during system start-up.
Message
This message tells you that...
WARNING: Speed Node file updated
- old file moved to /etc/conf/node.d/spd_nnnnnnnn
The speed node file has been updated to include
the revised number of ports.
Your old Speed node file is retained with the
file name shown in the message. 'nnnnnnnn'
is a unique number so that previous Speed
node files are not lost on updating.
You now have additional entries in the Speed
init file, existing entries are retained
unchanged. The automatic init file update is
necessary to make any additional nodes
available in the Speed Port Configuration
tool.
WARNING: New Speed ports detected
- /etc/conf/node.d/spd being updated
Hint
If you have modified your Speed node file, (for example you may have changed the default
permission for security reasons), you may wish to re-instate the previous node set-up for
existing Speed ports.
If you have not modified your Speed node file or do not require to retain the old settings you
may safely delete the file shown in the first message.
SPEED Serial Adaptors User guide
SCO UnixWare/SCO OpenServer 6
Page 101