Download User and reference manual

Alarm attributes
Crocus CNV
9.5 Interface alarms
Refer to Section 9.2 - Introduction to the alarm attributes for the general alarm attributes.
crocusIfConv<2m/Nx64><Tt/Cv>/<dteInterface>/alarmInfo
The different alarms related to the <dteInterface> object together with their explanation and their default
alarmMask and alarmLevel value are given in the following table:
The alarm …
linkDown
(for RS530, V35,
V36I)
linkDown
(for X21)
linkDown
(for Bridge)
linkDown
(for Router)
124
is generated …
Default value
alarmMask
alarmLevel
enabled
3
when no valid C signal is detected. I.e. the
connection between the Crocus CNV and the DTE
is down.
enabled
3
when there is no connection with the LAN. I.e. the
LAN is not connected or no valid LAN signals are
present.
enabled
3
when there is no connection between the router and
the Crocus CNV. Because this connection is made
by the interface connector, it is highly unlikely that
this alarm will be generated. However, when it does
occur it might indicate that the router interface is
faulty.
enabled
3
when no RTS signal is detected. I.e. the connection
between the Crocus CNV and the DTE is down.
The linkDown alarm is only generated if the attribute
rtsControl is set to external. If the attribute rtsControl is
set to internal, the linkDown alarm will never be
generated.
Reference manual