Download iQ Console System

7. Program Bus Assignment Keys: Each channel is assigned to any of the three main output buses
by selecting any (or all) of these program bus keys.
Generally, PGM-1 is the main on-air bus and other
buses are used for production or other programming
requirements. All program
outputs are post-fader and
post on-off function.
the value of that parameter (if any). Press the
key to exit.
Soft
In the QOR.32’s Web setup, you can also assign a
default function to the rotary encoder. Doing so allows adjustments to fader options, gain trim, input
gain trim, pan, or input selection to be made just by
rotating the knob.
9.
Always displays the output level of the IQ Program 1
bus. PGM 1-2 Meter:
10.
PGM 3-4 Meter:
This is a dual function meter.
The left side of this meter always displays the output level
for the Program 3 bus. The
right side of this meter displays
the output level of a bus that
may be selected by the operator by using the Meter Select
key (14). Options for this meter
are: PGM 4 or Follow Monitor.
The fourth bus functions
as a regular output bus, but
any sources feeding PGM4 are also sent to a special
Record bus that can feed a
dedicated recording device,
as well as to the Phone bus
that sends mix-minus audio
to any phone callers. These
buses operate independently
11. TALK to Backfeed: This
but simultaneously, allowkey allows the operator to ining jocks plenty of operastantly talkback to any phone
tional flexibility.
or codec source(s) by press»» PGM-4 bus audio output
ing a single key. Pressing
is post-fader, post-ON/
the TALK to Backfeed key
OFF.
routes the board operator’s
»» PGM-4 Record bus aumic to all existing backfeeds.
Figure 3-2: iQ Main - Callouts
dio output is post-fader, prei.e.: you can talk to a codec
ON/OFF.
or
phone
caller’s
mix-minus
»» Phone bus audio is sent to callers pre-fader, prefeed by simply pushing TALK to Backfeed.
ON/OFF.
12. Record: places the iQ in Record Mode. Moni8. Channel Options Control: This control
toring (CR Headphones) will switch from the current
operates in conjunction with the OLED fader dissource to the Record Bus, The 3rd meter will display
play. Pushing the rotary encoder selects OPTIONS
the Record Bus levels. Control Room Monitors and
mode, displaying various choices on the OLED
Preview speakers will be muted. Pressing a Record
beneath. Rotate to select the desired option, and
second time releases Record Mode and restores iQ
then push to “take.” Once an option has been seto its previous state.
lected, you can rotate the control again to adjust
©2011 Axia Audio
3: Console Operation • 25
the Off key while moving the fader up suppresses
turning the channel On.
• In fader-normal mode, the on/off status and
start/stop commands follow the channel ON/
OFF switches independently of the fader position.