Download ProcessView 8 - Manual

Introduction
Returns the history filter for the pen.
Possible values are:
Raw = 0
Average = 1
short HistoryFilter
Minimum = 2
Maximum = 3
Standard deviation = 4
Last sample = 5
Minimum with actual time = 6
Maximum with actual time = 7
double AutoResetLevel
Gets/sets the autoreset value for a pen in configuration
mode, if the totalizer mode is enabled.
double PreLoadValue
Gets/sets the preload value for a pen in configuration
mode, if the totalizer mode is enabled.
double PresetValue
Gets/sets the preset value for a pen in configuration
mode, if the totalizer mode is enabled.
Gets/sets the Integration factor value for a pen in
configuration mode, if the totalizer mode is enabled.
Possible values are:
double IntegrationFactor
1.0 (integration constant computed in seconds)
60.0 (integration constant computed in minutes)
3660.0 (integration constant computed in hours)
86400.0 (integration constant computed in days)
Gets/sets the integration direction value for a pen in
configuration mode, if the totalizer mode is enabled.
long IntegrationDir
Possible values are:
0 (Totalizer counts upward from 0.)
1 (Totalizer counts downward to 0.)
Gets/sets the totalizer mode value for a pen in
configuration mode if the totalizer mode is enabled.
Possible values are:
long TotalizerMode
0 (continuous mode)
1 (preload mode)
2 (preset)
boolean EnableTotalizer
Enables/disables the totalizer mode for a pen in
configuration mode.
Gets/sets the totalizer plotter mark size for the pen's
curve, if the totalizer mode is enabled.
Possible values are:
No marker = 0
long PlotterMark
Tiny = 1
Small = 2
Medium = 3
Big = 4
Huge = 5
long TotalizerUnits
Gets/sets the totalizer units value for a pen in
configuration mode, if the totalizer mode is enabled.
Possible values are:
7.73