Download Simulator Configuration Guide for Synopsys Models

L
Chapter 9: Using Cyclone with Synopsys Models
Simulator Configuration Guide
Cyclone genInterface Setup Files
This section describes the ModelAccess for Cyclone setup file syntax and usage.
Setup File Definition
Two sets of setup files are provided for genInterface:
1. Model-dependent setup information is stored in the following file:
$MA_CY/setup/synopsys_lm_hw.setup
This file is typically copied by each user from this central location into the their own
directory, where it can be edited for a particular session. Use of this setup file is
described in “Editing the Setup File” on page 184.
2. System-dependent setup information is stored in these three platform-specific files:
❍
$MA_CY/setup/synopsys_lm_hw.setup.hp700
❍
$MA_CY/setup/.synopsys_lm_hw.setup.solaris
These files are provided to allow a system administrator to update compiler and
linker information, if necessary. If the ANSI C compiler (acc) is used, then no
editing of these files should be required.
Search Path
Upon invocation, the genInterface program searches for the synopsys_lm_hw.setup file
and the.synopsys_lm_hw.setup.platform files in the following locations, in the order
listed:
1. Current working directory (files preceded by “.”)
2. User’s home directory (files preceded by “.”)
3. $MA_CY/setup (files without a “.” prefix).
System-Dependent Setup Options
The system-dependent setup files allow you to change default settings for genInterface.
A sample of the HP-UX version of the file is shown in Figure 12.
190
Synopsys, Inc.
July 31, 2001