Download CNC-Calc v2

CNC-Calc v2
29
The top part of the main configuration are the settings for toolpath
output, with the settings for the drawing grid at the bottom. The correct
settings for toolpath output depend on the machine and control that is to
run the NC code, you should consult the programming manual for the
machine if in doubt.
The settings for toolpath output are:
Turning: Select this for turning (lathe) output. This option is unavailable
for Heidenhain conversational NC code output.
Diameter programming: Selects whether X axis output is in diameter
measurement or in radius measurement. This option is only
available if turning (lathe) output is selected.
Arc center is specified as diameter: Selects whether the I value for arcs
is specified in diameter measurement or in radius measurement.
This option is only available if turning (lathe) output is selected.