Download LS-INGRID: A Pre-Processor And Three-Dimensional Mesh

INTERACTIVE COMMANDS
LS-INGRID
DI RE
Display radiation enclosure; (surface segments).
DI REL
Display radiation enclosure. (edge segments)
DI RX
Display X-rotational boundary conditions.
DI RXN m
Display extra nodes slaved to rigid body
material m.
DI RY
Display Y-rotational boundary conditions.
DI RZ
Display Z-rotational boundary conditions.
DI SBI
Display shell/brick interfaces.
DI SFC islid mslid
Display nodes which are part of sliding interface
definition islid.
mslid = "M": display master side.
mslid = "S": display slave side.
mslid = "B": display both sides.
DI SI islid mslid
Display slide surface islid; (surface segments).
mslid = "M": display master side
mslid = "S": display slave side
mslid = "B": display both sides
DI SL n isid
Display slide line n; (edge segments).
mslid = "M": display master side.
mslid = "S": display slave side.
mslid = "B": display both sides.
DI SPC
Display single point constraints.
DI SPD
Display springs and dampers.
DI SW s
Display stonewall s.
DI SY isym
Display symmetry plane isym.
DI SYSJ isym
Display symmetry plane isym.
DI TB
Display temperature boundary conditions.
DI TI
Display temperature initial conditions.
DI TRACER
Display tracer particles.
DI VB lc
Display velocity boundary conditions associated
with load curve lc.
DI VECT c
Display vectors of component c.
c = IV: initial velocity
c = IR: initial rotational velocity
c = IDV: initial distortional velocity
13.4