Download LS-INGRID: A Pre-Processor And Three-Dimensional Mesh
Transcript
CONTROL COMMANDS LS-INGRID MSCA s Scale factor for master thicknesses. (LS-910 and later). MTHI t Master side thickness. (LS-910 and later). NFAIL fs Normal failure stress. NOMERGE Coincident nodes are not merged. NSWS Nodes spot welded to surface. PNLM p Change master side penalty to p. PNLS p Change slave side penalty to p. PNLT p Change penalty to p. RADIUS t GA slideline option: Radius of rebar. SETS Shell edge tied to shell surface. SFAIL fs Shear failure stress. SINGLE Single sided slide surface. SL Sliding only. SSCA s Scale factor for slave thicknesses. (LS-910 and later). STHI t Slave side thickness. (LS-910 and later). SV Sliding with voids (default). T10 Type 10 interface. T11 Type 11 interface. This is the box/material limited automatic contact for shells in LS-910 and later. It is the single surface airbag contact for MVMA/DYNA3D. T12 Type 12 interface. Automatic contact for shells. (LS-910 and later). T13 Type 13 interface. (LS-920 and later. Converts to the similar type 11 in MVMA/DYNA3D). T14 Type 14 interface. Surface to surface eroding contact. (LS-920 and later). T15 Type 15 interface. Node to surface eroding contact. (LS-920 and later). T16 Type 16 interface. Single surface eroding 2.22