Download LS-INGRID: A Pre-Processor And Three-Dimensional Mesh

Transcript
CONTROL COMMANDS
LS-INGRID
MSCA s
Scale factor for master thicknesses. (LS-910
and later).
MTHI t
Master side thickness. (LS-910 and later).
NFAIL fs
Normal failure stress.
NOMERGE
Coincident nodes are not merged.
NSWS
Nodes spot welded to surface.
PNLM p
Change master side penalty to p.
PNLS p
Change slave side penalty to p.
PNLT p
Change penalty to p.
RADIUS t
GA slideline option: Radius of rebar.
SETS
Shell edge tied to shell surface.
SFAIL fs
Shear failure stress.
SINGLE
Single sided slide surface.
SL
Sliding only.
SSCA s
Scale factor for slave thicknesses. (LS-910 and
later).
STHI t
Slave side thickness. (LS-910 and later).
SV
Sliding with voids (default).
T10
Type 10 interface.
T11
Type 11 interface. This is the box/material
limited automatic contact for shells in LS-910
and later. It is the single surface airbag contact
for MVMA/DYNA3D.
T12
Type 12 interface. Automatic contact for shells.
(LS-910 and later).
T13
Type 13 interface. (LS-920 and later. Converts
to the similar type 11 in MVMA/DYNA3D).
T14
Type 14 interface. Surface to surface eroding
contact. (LS-920 and later).
T15
Type 15 interface. Node to surface eroding
contact. (LS-920 and later).
T16
Type 16 interface. Single surface eroding
2.22