Download User Manual
Transcript
1-20 INTRODUCTION ORBAN MODEL 6300 You can adjust the frequency and modulation level of the built-in line-up tone via the front panel or PC Remote software. You can use the front panel, the PC Remote software, or the opto-isolated remote control interface ports to activate the Test Tone. Built-in Calibrated Bypass Test Mode A BYPASS Test Mode is available to transparently pass line-up tones generated earlier in the system. It will also pass program material, with no gain reduction or protection against overmodulation. It can transparently pass any line-up tone applied to its input up to about 130% output modulation, at which point clipping may occur. Setting Output/Modulation Levels In a perfect world, one could set the peak level at OPTIMOD 6300’s output to 0 dBfs. However, there are at several potential problems that may make it desirable to set the modulation level slightly lower. First is asynchronous re-sampling, which we have discussed at length earlier in this chapter. (See page 1-13, for example.) If any digital processing that causes its output samples to be asynchronous to its input samples is used after OPTIMOD 6300’s output, this can cause the peak levels of individual samples to increase above the nominal threshold of limiting. This increase is typically less than 0.5dB. Second is additional processing, such as equalization. Equalization that applies boosts at certain frequencies is very likely to add peak level and thus cause clipping. However, equalization that attenuates certain frequencies can also cause overshoots because of added phase shifts. So be wary of any equalization and allow headroom to accommodate it. Third is headroom in lossy data compression systems. A well-designed perceptual encoder will accept samples up to 0dBfs and will have enough internal headroom to avoid clipping. However, there is no guarantee that receiver manufacturers or decoder providers will implement perceptual decoders with sufficient headroom to avoid clipping overshoots. Such overshoots are the inevitable side effect of increasing the quantization noise in the channel, and can be as large as 3-4dB. Most perceptual encoder algorithms are designed to have unity gain from input to output. So if peak levels at the input frequently come up to 0dBfs, peak levels at the output will frequently exceed 0dBfs (and will be clipped) unless the decoder algorithm is adjusted to have less than unity gain. Canny engineers familiarize themselves with the performance of real-world receivers and reduce the peak modulation of the transmissions if it turns out that most receivers are clipping due to perceptual encoding overshoots. Our experience to date suggests that allowing 3dB headroom will prevent audible overshoot-induced clipping in low bite-rate systems (e.g., 32 kbps streams), while 2dB is adequate for 128kbps and above. While some clipping may still occur, it will have a very low duty cycle and will almost certainly be inaudible.