1
Download Model 9500B
Transcript
Appendix D to Section 6 of the User’s Handbook for Model 9500B Model 9500B — Device Settings after ∗RST & Power On 6.D.1 Introduction ∗RST will reset the instrument to a defined condition, stated for each applicable command. The reset condition is not dependent on past-use history of the instrument except as noted below: ∗RST does not affect the following: • • • • the selected address of the instrument; calibration data that affect specifications; SRQ mask conditions; the contents of: the Status Byte Register; the Status Byte Enable Register; the Standard Event Status Register; the Standard Event Status Enable Register; the SCPI Operation Status Register; the SCPI Operation Status Enable Register; the SCPI Questionable Status Register; the SCPI Questionable Status Enable Register; • the state of the IEEE 488.1 interface; • the Error Queue; • the Power-on Status Clear flag setting; • the Protected User Data Query response. The 'Enable Macro Command' (∗EMC) is not used. The 'Define Device Trigger Command' (∗DDT) is not used. Parallel Poll is not implemented in the 9500B. ∗RST enforces the following states: • • The 9500B reverts to Manual/Procedure mode; the 9500B is returned to 'Operation Complete Command Idle State' (OCIS); • • • the 9500B is returned to 'Operation Complete Query Idle State' (OQIS); Settings Related to Common IEEE 488.2 Commands are as detailed in paras 6.D.2, overleaf; Settings related to SCPI Commands are as detailed in paras 6.D.3, overleaf; 6.D.2 Final Width = 215mm General Active Mode: The 9500 can power-up in either 'Manual' or 'Procedure' mode, but Manual Mode or Calibration mode must be selected for Remote Operation. The required mode is selected by pressing Mode key on front panel and choosing from the Mode Menu (Calibration mode requires a password). Device I/D (Serial Number) Factory serial number preserved Protected User Data Previous entry preserved Status Reporting Conditions: Status Byte Register Status Byte Enable Register Event Status Register Event Status Enable Register Operation Status Event Register Operation Status Enable Register Questionable Status Event Register Questionable Status Enable Register Error Queue Depends on state of ∗PSC Depends on state of ∗PSC Depends on state of ∗PSC Depends on state of ∗PSC Depends on state of ∗PSC Depends on state of ∗PSC Depends on state of ∗PSC Depends on state of ∗PSC Empty until first error is detected Appendix D to Section 6: 9500B System Operation — Device Settings after ∗RST 6-D1
