Download USER`S MANUAL - SewTrain.com

A. Insert USB flash drive containing the pattern to
insert overlap sewing stitch.
B. Press MODE key.
C. After moving to “2. Program” menu by using
direction key
, press ENTER key. At this
time, the upper feed plate comes down and
moves to the original point.
ORIGIN
X:+0000.00A N:00000
Y:+0000.00A
Function Code?
D. After pressing READ key, input the pattern
number to insert overlap sewing stitch by using
digit key and read in the pattern by pressing
ENTER key. (For example, input [0][0][1] to
read the pattern number 001.)
014:PTRN
NO
:001
E. Go to the location that pattern data ends in
order to apply overlap function by using FORW
and BACK key.
CIRCLE
X:+0000.00A N:00030
Y:+0010.00A
Function Code?
F. After pressing CODE key, if you know the
function number related to pattern programming,
input three-figure digit number 042 and if you
do not know the number, press ENTER key.
Then, after moving to “042:OVLAP STI” by
using direction key
, press ENTER key.
<Function Code>
042:OVLAP
STI <
043:SYMMETRY
X
044:SYMMETRY
Y
G. Input the number of overlap stitch to insert and
press ENTER key.
042:OVLAP
STI
OVNUM:4[STITCH]
H. Confirm if back tack was made properly by
using FORW and BACK key.
CIRCLE
X:-0009.20A N:00034
Y:+0003.70A
Function Code?
(Reference) This function can be accomplished in case the
point property that you want to add the function should be
the *NOTE1. If the property is the code that is not
displayed in the *NOTE1 (trimming the 2nd starting point
stop code), the relevant function will not be performed.
READ
NOTE1: Operation function table regarding the pattern
programming in the parameter manual (shadowing part)
No.4~10, No.19~39, No.40
85