Download PCI384
Transcript
Chapter 3: Installation Before starting, note the following about the mechanical aspects of the PCI384: • The PCI384 meets PCI Revision 2.1 • The PCI384 has been tested for mechanical compatibility and installs in most systems without issue Handling Instructions Caution: Static electricity can damage the adapter. Do not open the static-protective package containing the adapter until you are instructed to do so. Follow these handling instructions. • Use the static-protective bag (with the adapter still inside) as a grounding device and touch it to a metal expansion slot cover for at least two seconds. This action reduces any static electricity from the package and from your body. • Do not touch any exposed printed circuitry. • Do not place the adapter on the computer cover or a metal table. • Prevent other people from touching the adapter. • Limit your movement, because your movement can cause static-electricity buildup. • Always handle the adapter carefully. • If you put the adapter down after you have removed it from the package, place the adapter on the static-protective package on a flat surface. • We recommend you use static-protective wrist straps during the installation. Connect them to the computer chassis after you have removed the cover from the computer. Configuration Jumpers The configuration jumpers for the PCI384 are at P3 (right angle header on the base board), accessible between the base and mezzanine boards on the side opposite the PCI card edge fingers, as shown in Figure 3-1, “Configuration Jumpers,” below. Figure 3-1: Configuration Jumpers 8 1 28