Download SurvCE v. 2 Manual

offset is for a curb or ditch, and is prompted in the form of “distance over” and
“elevation change up or down”.



Settings: The Settings button returns to the Settings dialog, allowing you to
load another cutsheet list or specify more or less special stations. Note that in
Settings, if you called for a Station and Offset List, then most of the options in
the Offset Stakeout dialog are fixed, and your only choice is to stake the
particular offsets named in the list. Also note that Offset Stakeout, when not
using a List, allows for the staking of three points on the Left or Right Side:
Center, Curb (or Ditch) and EOP. On the left, it becomes LEOP, LCurb or
LDitch. On the right, it becomes REOP, RCurb or RDitch. You must enter
data for the right as well as the left if you are staking both sides of a road. So
there are five points total that can be staked when you use the dialog entry,
since the centerline is covered in both the Left and Right scenarios.
Back: The Back button returns to the first screen.
Station: This is where you enter the station you wish to stakeout.

Station +: You can advance to the next station as defined by the
alignment points or station interval using the right green arrow icons.

Station -: You can go back to the previous station as defined by the
alignment points or station interval using the left green arrow icon.

Station List: Select a specific station using the station list icon.
p248