1
Download Diagnostics Manual - Service, Support
Transcript
03/2009 Overview of Alarms NCK alarms Remedy: 61360 Call the hotline! [Channel %1: ] Block %2: Log job undefined - continue with RESET Parameters: %1 = Channel number %2 = Block number, label channel number Definitions: Alarm triggered by following cycle: CYCLE106. Cycle CYCLE106 was called by an incorrect parameter. Remedy: Check cycle call for CYCLE106, specifically the call parameter. 61361 [Channel %1: ] Block %2: Variable cannot be recorded Parameters: %1 = Channel number %2 = Block number, label channel number Definitions: The alarm is triggerd by the following cycles: CYCLE105. The value specified in _PROTVAL[] cannot be logged. Remedy: Check parameter _PROTVAL[]. 61362 [Channel %1: ] Block %2: Cycle118: No. of values too large Parameters: %1 = Channel number %2 = Block number, label channel number Definitions: The alarm is triggerd by the following cycles: CYCLE118. 4th parameter for CYCLE118 is larger than 10. Remedy: Reduce the 4th parameter (PAR4) of CYCLE118. 61363 [Channel %1: ] Block %2: Max. no. of value lines for recording exceeded Parameters: %1 = Channel number %2 = Block number, label channel number Definitions: Maximum number of value lines exceeded. Alarm triggerd by following cycle: CYCLE105. Remedy: Reduce the number of value lines. Check parameter _PROTFORM[4]. 61364 Parameters: [Channel %1: ] Block %2: Check distance from measuring point 1 to measuring point 2 %1 = Channel number %2 = Block number, label channel number Definitions: Alarm triggered by following cycles: CYCLE998 Remedy: Check parameter incremental infeed depth (_ID) 61365 Parameters: [Channel %1: ] Block %2: Check circular feed %1 = Channel number %2 = Block number, label channel number Definitions: Alarm triggered by following cycles: CYCLE979 Remedy: For 840D: - Check parameter _RF For 840D sl: - Check parameter FP 61366 [Channel %1: ] Block %2: Direction of rotation for tool measurement with rotating spindle not specified. Parameters: %1 = Channel number %2 = Block number, label channel number Definitions: The alarm is triggerd by the following cycles: CYCLE971 Remedy: For 840D: - Check parameter _CM[5] in GUD6, permissible values are 3 (corresponds to M3) and 4 (corresponds to M4) For 840D sl: - Check setting data 54674 $SNS_MEA_CM_SPIND_ROT_DIR, permissible values are 3 (corresponds to M3) and 4 (corresponds to M4) © Siemens AG, 2009. All Rights Reserved SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009 2-503
