Download NWare Device Reference - Peavey Digital Research

NWare Device Reference
Configure Discovery Server
IP address start
The start IP address for the range that will be scanned during
the discovery process.
If you want to use a broadcast address, which will
provide better performance when scanning a large
range of addresses, type the broadcast address.
When a large number of devices are discovered, using a
broadcast address will greatly reduce the impact on the
network. The format of a broadcast address is
x.x.x.255. This will broadcast to the entire /24 subnet.
You can also use x.x.255.255 to broadcast to a /16
subnet, but the impact of addressing such a large
number of devices must be considered carefully.
Note: Not all SNMP devices will respond to a
broadcast addresses. Check that the devices you are
using are compatible.
IP address end
The end IP address for the range that will be scanned during the
discovery process.
If you are using a broadcast address, leave this box blank.
Read community
The read community string (password) for accessing devices on
the network during the discovery process.
Update period (mins)
The interval to use between scans for devices on the network.
Switch port support
Allows devices to be detected via the switch port to which they
are connected. Both the switch and the device must support
SNMP. Furthermore, the device must respond to the SNMP
discovery process.
Controls
Slot <number>: PCI-1761
Digital Ins (1-8)
Lit green when the corresponding input channel on the card is
receiving data.
Relays (1-8)
When clicked, the corresponding relay on the card is triggered
or reset.
Lit green when a relay is triggered.
Present
May 28, 2015
Lit green when a PC-1761 card is installed in the slot.
Version 1.7.2.3
167