1
Download NWare Device Reference - Peavey Digital Research
Transcript
Chapter 2 - DSP . Arcane Components Full Wave Rectifier Purpose The full wave rectifier inverts the negative part of the signal passing through it. It is useful for building signal detectors. Multiplier Purpose Each output of the multiplier is simply the product of the corresponding input, and the input labeled G. For example, if you connected G to a DC generator, the level of the DC generator would control the gain of each channel. If you hooked it to a low frequency oscillator, the gain will vary up and down. You can also use it for special effects, multiplying two signals together. Detectors Maximum Detector Purpose The Maximum detector compares the input signals on a per sample basis and simply outputs the highest. It is useful for inexpensively measuring several channels. Device Properties Input count Input count selects the number of inputs to be compared. Peak Detector Purpose The Peak detector shows the power used to deliver the peak input signal. It is similar to the RMS detector because the meter shows overall power level; however, it surpasses the relative power in most instances, so it does not accurately show system load in the same way that the RMS detector does. The Peak detector detects the positive peaks in the input signal(s) and incorporates an exponential signal decay, up to 67% before the next peak is detected. Device Properties Number of Inputs Set the desired number of inputs. Controls 176 Version 1.7.2.3 May 28, 2015
