Download User`s manual complete

Transcript
SECTION 1
GENERAL DESCRIPTION
This section describes the features of the M4503 APM Decorator
High Speed Logic Module. This includes the functional description,
alarms detected, etc.
________________________________________________________
1.1 FEATURES
•
Performs high speed control functions of the APM Decorator to
speeds in excess of 2400 CPM.
•
High speed front-end upgrade package which interfaces with
existing control system.
•
Accurate detection of misloaded cans and trip cam control
eliminates inside deco and varnish problems.
•
Accurate speed compensated single can (bad can) pin chain blowoff reduces scrap and eliminates silver cans down the line.
•
Single select-a-can QC pin chain blow-off allows operator to blow
off a can from a selected spindle (or blanket) to verify print
quality of each blanket with machine running at full production
speeds.
•
Can gate open/close control.
•
Alarm detection: infeed track jam, no can transfer (can on
mandrel), and timing signal fail detection.
•
Data Acquisition: Total number of good cans printed, total
number of blow-offs, trips per spindle, etc. (for both current shift
and last shift).
•
Built-in 2 Line X 40 character sealed display with 24 key
membrane keypad allows local viewing of collected data (can
count, blow-off count, trips per spindle) by operator and set-up of
all user variables (passcode protected or key switch enabled) by
authorized personnel.
•
Interfaces directly with machine mounted resolver, can/no can
sensor and all trip and blow-off solenoids.
HSL-DC6 User’s Manual
SYSTEMS Electronics Group
-1-