Download man Pages(7): Device Network Interfaces

Devices
fas ( 7D )
Cannot allocate soft state
Cannot alloc dma handle
Cannot alloc cmd area
Cannot create kmem_cache
Driver was unable to allocate memory for internal data structures.
Unable to map FAS366 registers
Driver was unable to map device registers; check for bad hardware. Driver did
not attach to device; SCSI devices will be inaccessible.
Cannot add intr
Driver could not add it’s interrupt service routine to the kernel.
Cannot map dma
Driver was unable to locate a dma controller. This is an auto-configuration error.
Cannot bind cmdarea
Driver was unable to bind the dma handle to an address.
Cannot create devctl minor node
Driver is unable to create a minor node for the controller.
Cannot attach
The driver was unable to attach; usually follows another warning that indicates
why attach failed.
Disabled TQ since disconnects are disabled
Tagged queuing was disabled because disconnects were disabled in scsi-options.
Bad clock frequency
Check for bad hardware.
Sync of pkt (<address>) failed
Syncing a SCSI packet failed. Refer to scsi_sync_pkt(9F).
All tags in use!
The driver could not allocate another tag number. The target devices do not
properly support tagged queuing.
Cannot alloc tag queue
The driver could not allocate space for tag queue.
Gross error in FAS366 status
The driver experienced severe SCSI bus problems. Check cables and terminator.
Spurious interrupt
The driver received an interrupt while the hardware was not interrupting.
Lost state in phasemanage
The driver is confused about the state of the SCSI bus.
Unrecoverable DMA error during selection
The DMA controller experienced host SBus problems. Check for bad hardware.
Bad sequence step (<step number>) in
The FAS366 hardware reported a bad sequence step. Check for bad hardware.
modified 7 Feb 1997
SunOS 5.6
7D-115