Download Solid State NMR: AVANCE Solids User Manual - Pascal-Man

Transcript
Basic Setup Procedures
Since glycine may exist in two different crystal modifications with very different CP-parameters,
and since packing of the spinner determines crucially the achievable S/N value, it is useful to
prepare a reference spinner with pure α-glycine, finely powdered and densely packed. α-glycine is prepared by dissolution of glycine in distilled water and precipitation with acetone, quick
filtering and careful drying in a desiccator. Drying is important because wet glycine may readily
transform, especially when kept warm, into γ-glycine. α-glycine has two carbons with shifts of
176.03 and 43.5 ppm. γ-glycine shows resonances somewhat shifted to higher field, sharper
lines, longer proton T1 and shorter proton T1ρ which results in longer experiment time and less
signal to noise.
Spin the glycine sample at 5 kHz (7mm spinner), or 10 kHz (smaller spinners 4, 3.2 or 2.5),
tune and match the probe.
The glycine cp/mas 13C-spectrum taken under the same conditions as adamantane previously
will look like in Figure 3.23., far from optimum:
Figure 3.23. Display Showing α-Glycine Taken Under Adamantane Conditions, 4 scans
The figure above shows α-glycine taken under adamantane conditions, 4 scans: Incorrect carrier setting, α-carbon at 43 ppm insufficiently decoupled. Angle is set correctly, because carboxyl peak at 176.03 ppm shows a narrow lorentzian line shape. HH condition looks okay.
Now reset the carrier as shown in Figure 3.13.. o1p should be around 100 ppm, in the middle
of most carbon spectra. Acquire a spectrum, set the plot limits (Figure 3.14., Figure 3.15.) for
the peak at 43 ppm, and start popt, optimizing o2 for maximum signal (+/- 2000 Hz around the
current position) in steps of 500 Hz. The following result will be obtained:
36 (261)
BRUKER BIOSPIN
User Manual Version 001