Download Solid State NMR: AVANCE Solids User Manual - Pascal-Man
Transcript
Basic Setup Procedures Since glycine may exist in two different crystal modifications with very different CP-parameters, and since packing of the spinner determines crucially the achievable S/N value, it is useful to prepare a reference spinner with pure α-glycine, finely powdered and densely packed. α-glycine is prepared by dissolution of glycine in distilled water and precipitation with acetone, quick filtering and careful drying in a desiccator. Drying is important because wet glycine may readily transform, especially when kept warm, into γ-glycine. α-glycine has two carbons with shifts of 176.03 and 43.5 ppm. γ-glycine shows resonances somewhat shifted to higher field, sharper lines, longer proton T1 and shorter proton T1ρ which results in longer experiment time and less signal to noise. Spin the glycine sample at 5 kHz (7mm spinner), or 10 kHz (smaller spinners 4, 3.2 or 2.5), tune and match the probe. The glycine cp/mas 13C-spectrum taken under the same conditions as adamantane previously will look like in Figure 3.23., far from optimum: Figure 3.23. Display Showing α-Glycine Taken Under Adamantane Conditions, 4 scans The figure above shows α-glycine taken under adamantane conditions, 4 scans: Incorrect carrier setting, α-carbon at 43 ppm insufficiently decoupled. Angle is set correctly, because carboxyl peak at 176.03 ppm shows a narrow lorentzian line shape. HH condition looks okay. Now reset the carrier as shown in Figure 3.13.. o1p should be around 100 ppm, in the middle of most carbon spectra. Acquire a spectrum, set the plot limits (Figure 3.14., Figure 3.15.) for the peak at 43 ppm, and start popt, optimizing o2 for maximum signal (+/- 2000 Hz around the current position) in steps of 500 Hz. The following result will be obtained: 36 (261) BRUKER BIOSPIN User Manual Version 001