Download NEO VR Command Center Contrl Software Application User Manual

Transcript
Chapter 4: Using the VR View
Trimming an ID
Trimming an ID permanently removes a portion of it. Trimming can
only occur on actual clips, and not on a playlist or sub clip. When
trimming a clip, all the audio and video material will be removed
between the in point (Mark In) and out point (Mark Out). The section
removed will no longer exist and out point will be positioned at the in
point. This means it is possible to completely remove sections within a
clip and shorten the clip's duration. Once a trim has occurred the storage
required by the section removed is released.
NOTE
The Trim feature is available in the full version of Command Center
only.
To trim an ID, follow these steps:
1. Load the ID you wish to trim. See “Loading an ID” on page 44 for
more information.
2. Use the transport controls on the VR View or the Shuttle knob (if
you have one) to search from the start of the clip for the first video
frame you want to delete. See “Cueing and Playing IDs” on page 45
for information on the various transport control options you may
have available.
3. Press In to mark this as the first frame of the trim.
4. Search for the last video frame you wish to delete from the clip.
5. Press Out to mark this frame as the last frame of the trim.
6. From the Main menu, click ID and then click Trim. A message
will pop up and ask you to confirm the trim. Click OK and the
frames from mark-in to mark-out are permanently removed.
Adjusting Audio and Video Levels
There are two sets of proc amplifiers for adjusting both the input and
output audio and video levels. They must be turned on by an
administrator in the settings section of the program.
See “Adjusting Video Proc Amps” on page 100.
NEO VR Command Center User Manual
59