Download NEO VR Command Center Contrl Software Application User Manual
Transcript
Chapter 4: Using the VR View Trimming an ID Trimming an ID permanently removes a portion of it. Trimming can only occur on actual clips, and not on a playlist or sub clip. When trimming a clip, all the audio and video material will be removed between the in point (Mark In) and out point (Mark Out). The section removed will no longer exist and out point will be positioned at the in point. This means it is possible to completely remove sections within a clip and shorten the clip's duration. Once a trim has occurred the storage required by the section removed is released. NOTE The Trim feature is available in the full version of Command Center only. To trim an ID, follow these steps: 1. Load the ID you wish to trim. See “Loading an ID” on page 44 for more information. 2. Use the transport controls on the VR View or the Shuttle knob (if you have one) to search from the start of the clip for the first video frame you want to delete. See “Cueing and Playing IDs” on page 45 for information on the various transport control options you may have available. 3. Press In to mark this as the first frame of the trim. 4. Search for the last video frame you wish to delete from the clip. 5. Press Out to mark this frame as the last frame of the trim. 6. From the Main menu, click ID and then click Trim. A message will pop up and ask you to confirm the trim. Click OK and the frames from mark-in to mark-out are permanently removed. Adjusting Audio and Video Levels There are two sets of proc amplifiers for adjusting both the input and output audio and video levels. They must be turned on by an administrator in the settings section of the program. See “Adjusting Video Proc Amps” on page 100. NEO VR Command Center User Manual 59