Download windows manual elx

2. Configuration
FC/FCoE Driver Configuration
Table 2-1 Storport Miniport Driver Parameters (Continued)
Parameter
Definitions
ExtTransferSize
ExtTransferSize is an initialization-time
parameter that affects the maximum SGL that the
driver can handle, which determines the
maximum I/O size that a port will support.
Activation
Requirement
Adapter/Protocol
LightPulse adapters
only including the
LPe16000 HBAs.
If set to 0 = the maximum default transfer size is
512KB for all controller models.
If set to 1= the maximum transfer size is 1MB.
If set to 2 = the maximum transfer size is 2MB.
If set to 3 = the maximum transfer size is 4MB.
Value: 0–3
Default = 0 (disabled)
FrameSizeMSB=n
FrameSizeMSB controls the upper byte of receive Reset
FrameSize if issued in PLOGI. This allows the
FrameSize to be constrained on 256-byte
increments from 256 (1) to 2048 (8).
Value: 0–8
Default = 0
InitTimeout=n
Determines the number of time-out seconds
during driver initialization for the link to come
up. If the link fails to come up by InitTimeout,
driver initialization exits but is still successful. If
the link comes up before InitTimeout, the driver
sets double the amount for discovery to
complete.
Reboot
Value: 5–30 seconds or 0x5–0x1E (hex)
Default = 15 seconds (0xF)
LimTransferSize
Limits maximum transfer size when non-zero to
selectable values.
Reboot
Values:
0 = Port Default
1 = 64Kb
2 = 128 Kb
3 = 256Kb
LinkSpeed=n
LinkSpeed has significance only if the adapter
supports speeds other than one Gb/s.
Reset
FC Only
Value: Auto-select, 1 Gb/s, 2 Gb/s, 4 Gb/s, 8
Gb/s
Default = Auto-select
Note: Setting this option incorrectly can cause
the adapter to fail to initialize.
Emulex Drivers for Windows User Manual
P008011-01A Rev. A
34