Download Flow Control User Manual

SystemConsoleSwitch User Manual
Modem does not
disconnect
A.
Make certain that the modem hang-up string,
which is stored in the set-up menu, is the correct
string for the modem. If the hang-up string is
incorrect, go to the set-up menu and change the
hang-up string to one that is appropriate for the
modem.
Printer prints on the
perforations or has
more or less than a
page of data.
A.
Check the settings for number of lines on a
printed page in the SCS Set-Up Menu. The
default setting is 56 lines per page.
Incorrect Communication
Parameters or Improper
Cabling
A.
Most problems associated with connected
devices will either be incorrect communication
parameters (baud rate, stop bits, parity, bits/byte,
etc.) or DTE/DCE cabling issues. Always check
the spooler modules for correct baud rates etc.
when a problem occurs. Also check the appendix
for the correct cables for the attached devices.
SCS doesn't find
a connected slave
A.
One problem is that the DB9 connector is not
securely fastened and the cable becomes lose
and communications become intermittent.
B.
If the message Slave n configured does not
appear, use the configure slave command a
second time.
NOTE: The display will always show
the message Slave n not found
(where n = next slave number)
on the last line of the display, when
less than 9 slaves are connected.
The purpose of the message is to
indicate to the user, that the next
slave is nonexistent (there are no
more installed slaves at this point).
B-ii