Download TSC695F 32-bit Sparc Processor
Transcript
3.6.8 Timers In software debug mode the timers are controlled by a system register bit (phlt – bit 4 in Timer Control Register – TIMCTR) and an external pin (DEBUG). Setting the external pin IWDE to VCC enables the Watchdog Timer. Otherwise the watchdog function must be externally provided. While the halt mode is active, the timers are temporary halted. Figure 3-4 Timers Halt 31 15 0 SYSCTR – (System Control Register) IWDE reset Watchdog Timer gpt int RTC rtc int 3.6.8.1 DEBUG Watchdog Clock clk General Purpose Timer Real Time Clock Timer General-purpose Timer clk enable clk SYSCLK 31 clk enable 7 6 UARTB Halt UARTA Halt Peripherals Halt clk 5 4 3 0 TIMCTR (Timer Control Register) ph lt wd int clk enable The General-purpose Timer (GPT) provides, in addition to a generalized counter function, a mechanism for setting the step size in which actual time counts are performed (a two-stage counter). This timer/counter pulse generator consists of two parts: pre-SCALER (GPTSR): it is a counter to adjust the step size in which counter does the actual time count. COUNTER (GPTCR): it is a counter to actually count time in steps as set by the value in scaler. The counter is decremented when the scaler reaches zero. Figure 1. GPT Implementation Set Preload Cnt. SYSCLK Set Preload Cnt. 16-bit Scaler zero indication GPT Interrupt 32-bit Counter Control [enable, (periph_halt•DEBUG), load, re-load, hold, stop at zero] GPT is clocked by the internal system clock. The timer is programmable by writing to the Timer Control Register (TIMCTR). They are possible to program to be either of singleshot type or periodical type and in both cases generate an interrupt when the delay time TSC695F User Manual 3-27 4148H–AERO–12/03