Download CP6000 - Kontron
Transcript
Functional Description CP6000 Note ... If the CP6000 is ordered for extended temperature range (-40°C to +85°C), the mounted heat sink extends partly over the area where the HDD is intended to be installed. For this reason, it is not possible to directly install a 2.5" HDD on this CP6000 version. Each EIDE interface provides support for two devices (one master and one slave) and the two EIDE interfaces together support a maximum of 4 devices. All hard disks can be used in cylinder head sector (CHS) mode with the BIOS also supporting the logical block addressing (LBA) mode. Figure 2-8: Connecting an Onboard 2.5" HDD to CP6000 via Parallel ATA PRELIMINARY 44-Pin Cable 27942.05.UG.VC.051020/172758 2.5” Parallel ATA HDD Page 2 - 18 © 2005 Kontron Modular Computers GmbH ID 27942, Rev. 05