Download Multigrow User Manual

Multigrow User Guide
Off
When a group is inactive all relative information for the group is displayed, the only valid action from an off group is to manually Irrigate Now. The
reason and info listed in an off group are the information from the last irrigation for the group.
Pending
If a group is triggered by cannot run yet because maximum number of groups or system capacity has been reached the group will become pending.
WHen this occurs the group will turn a light blue to indicate this, when a group is pending it can be manually cleared by pressing the Clear Pending
button now visible in the action field.
Pending (Batch System)
When a group is trigger on a batch system the group must wait for the batch tank to be ready, this makes the group enter the pending state but being
held off by the batching module. The group will turn a blueish colour to indicated this, the current state of the batching module will also be displayed in
black underneath the Pending state message. Like a normal pending group these groups can also be cleared, note that if this happens the batching
system will continue to run until a stable state is achieved. If the group is cleared the batch system will stop dosing but will continue to fill or complete
a stir cycle if that was the operation it was doing, the tank will most likely be left in a waiting full state if this sequence occurs.
On
When a group becomes active it will turn green to indicated this, the state will also be updated to On. When a group becomes active the info box will
be updated with the time of the trigger plus display the estimated time remaining for the group. Since a group has no knowledge of when it maybe
interrupted or held of because of flow the time is only an estimate. The station field will also be populated with the active stations within the group.
While a group is active the action button changes to Pause Now and Cancel Now these are the two valid options.
On (Multiple Stations)
If a group has been setup to use multiple stations it will operate exactly the same as a single stations group. The stations field will just contain more
enters for the number of stations the group is allowed to run. If the group does not or cannot run the maximum number of stations as allowed field will
still be displayed.
On (Pending)
A group may take a long time to finish a single irrigation cycle of all the groups configured. It is possible that since the time the group has started a
new trigger has been requested for the group even though it is still active. If this happens the new trigger will be queued (Pending) until the group has
finished running, once the group has finished irrigating it will then process the pending trigger and the group will start running again. In this state the
Ver 1.00
261
© 2014 Autogrow Systems Ltd