1
Download Multigrow User Manual
Transcript
Multigrow User Guide Name Description Combo Enable Auto Change Normally the shade manager will only change the combination when the light level changes. Ticking this checkbox will make re-evaluate the conditions to find the best combination and change to it every time period specified in the Change After field Change After When the Enable Auto Change checkbox is ticked this field specifies the how often the auto change should occur Each combination can be viewed on the readings page. Screens The screens table shows some basic information about the screens: When you click on the expander button for a screen you will see some control options: General Field Description State The current state of the screen Enable Min Pos When ticked the screen will never go to less than the percentage specified in Min Position Min Position Don't let the screen go to less that this (if the Enable Min Pos checkbox is ticked) Close on Rain When ticked, the screen will go to the percent specified Override Override the screen to the position specified Enable Stepping Prevent thermal shock to the plants by opening the screen in steps if the temperature inside and outside is quite different Crack for Temperature This section will only appear when the Crack for Temp checkbox is ticked in the configuration section for the screen If the screens are trapping temperature too effectively the air temperature may become too hot. To let some of this hot air out it is possible to crack the screens once the temperature reaches a certain value. Ver 1.00 69 © 2014 Autogrow Systems Ltd
