Download User manual

Transcript
Shield for the segment coupler SC12Ex
5.6
Shield for the segment coupler SC12Ex
In order to avoid irradiation of the data transmission by variable disturbances, the PROFIBUS-DP cable
must be layed and connected in regard to the shield according to the requirements. Here, take into
consideration that electrical fields are effectively suppressed by one-sided, grounded shielding.
The more frequently occurring magnetic fields are often suppressed only by two-sided, grounded
shielding.
With two-sided, grounded shielding no equalizing currents must flow across the shield because of
potential differences from one connection point to another. Here, possible capacitive grounding may
provide a solution. This means the shield is not directly connected to the equipotential bonding but
across a capacity.
The shield design must match the overall design. Four shield designs can be used and are supported
by the coupler system SC12Ex, as well as by the current module racks with the help of different shield
connections.
1. The connections are connected to the earth potential on both sides –"hard" grounded on both sides
(conditional recommendation).
2. "The connection on the feeding device is "hard" grounded; the connections of all segment
participants are capacitively grounded." page 220 (recommended)
3. The connection on the feeding device is "capacitively" grounded; the connections of all segment
participants are "hard" grounded (not recommended).
4. The connection on the feeding device is "capacitively" grounded; the connections of all segment
participants are also "capacitively" grounded (not recommended).
Note
When delivered, the shield is capacitively connected to the earth potential. In order to have
direct earth, the insulating disk must be removed from under the screw marked "Shield".
"Shield connection SC12Ex" page 217.
Figure 92:
Shield connection
SC12Ex
D301266 0113 - excom®
217