Download QnUCPU User`s Manual (Function Explanation, Program

Transcript
CHAPTER9 DEVICES
9
●
When debugging a program, the input (X) can be set to on or off by the following:
• Device test in GX Developer
• OUT Xn instruction
2
OUTX1
ON/OFF command
3
X1
Figure 9.5 Input (X) on/off with the OUT Xn instruction
4
●
The input (X) can also be used for the following.
• Refresh target device (CPU module side) of RX in CC-Link
• Refresh target device (CPU module side) of CC-Link IE controller network or MELSECNET/H
5
6
7
8
9.2 Internal User Device
9.2.1 Input (X)
9-7