Download "user manual"

Transcript
MELSEC-A
7. Other Functions
(f)
During the speed-change processing, 1 is stored in the during-speed-change flag (the
device below). Upon completion of the speed-change processing, the flag becomes O.
~
(g)
Even when the operation pattern is continuous locus control(11 ), the operation speed can
be changed as soon as the speed change request is made.
However, the speed will not be changed if a distance required to change the speed to the
specified speed cannot be secured.
<Operation timing during the processing of positioning-operation speed change>
v
Speed change to V2
Speed change to V3
VI
-—I
1
1
11
[1
It
1[
V2
1,
i;
Positioning operation by VI
‘\
<--”
\
t
-t
11
11
1
During-speed-changeprocessing flag
L
(3)
Speed change request with the new speed value at “O”
(a)
When a speed change request is made with the new speed value at ‘O” during operation
(excluding the manual pulse generator operation), the operation decelerates to stop and the
device’s speed change O flag is turned on.
(b)
During the interpolation control, the speed change O flag (the device below) of the axis
(reference axis) indicated blow turns on.
Interpolation axis
Reference axia
Devics number
L’
During the interpolation control by axes 1 and 2
Axis 1
RX(n+2)2
(c)
Setting the new speed value to a value other than O changes the speed change O flag to O,
thus continuing the operation.
(d)
When requesting the speed change to the new speed value O, even if the speed becomes O,
the BUSY signal will remain on.
At this time, the axis stops. However, there are no changes in the axis operation status.
7-11