Download User Manual - Mirai Inter-Tech
Transcript
8. Operation 8.1 Power Supply Timing Ezi-SERVO Plus-R is supplied power through drive module to motor. Therefore, connect the drive and the motor with a cable and then supply power to the drive module. After power is supplied, the motor is basically set to Servo OFF. 8.2 Servo ON Operation After power is supplied, set the drive module to Servo ON as follows. ① Click ‘Servo OFF’ button at the User Program(GUI). ② Give the drive a command through DLL library. ③ Assign ‘Servo ON’ to a control input pin, and supply the drive with the signal through the pin. After Servo ON command is given, In-position is finished to the time as shown below. Servo ON Commander In-Position t1 ‘t1’ is the time until Servo ON command is given and then the position is decided. It is about 800 msec. It is subject to the rising time of supplying power and the motor status. 8.3 Operation Mode This controller can do three control operations such as I/O command, communication command(DLL program), and User Program(GUI) (1) I/O Command Mode This controller can execute control operation like in-position by I/O command transmitted from the upper controller. The in-position control operation is executed by operating position table with I/O command. (2) Communication Command Mode This controller can execute control operation like in-position by command transmitted from the upper controller. The in-position control operation is executed by operating position table with I/O command Position Table Operation Sequence In case of Ezi-SERVO Plus-R, the system can execute continuous operation by position table at the I/O command mode. - 33 -