Download Robotics user manual

Transcript
2 How to build stations
2.2.2 Two robot systems having different task frame positions
Continued
5 Modify the task frame position of the conveyor mechanism. See Set Task
Frames on page 411.
NOTE! Before modifying the task frame, make a note of the current conveyor
position in world coordinates. After modifying the task frame, move the
conveyor back to the position it was before modifying the task frame.
6 Modify the baseframe positions of robot (system 2).
Repeat step 2 to modify the baseframe position of the robot (system 2)
a Move the mechanical unit (robot) to its new location.
b See Updating the baseframe position on page 412 to update the
baseframe position of the robot.
c Repeat steps 1 and 2 to modify the baseframe position of the robot.
d In the System Configuration window, click OK. When asked if you
want to restart the system, answer Yes. Close the System
Configuration window.
7 Modify the baseframe position of the conveyor (system 2).
a In the Offline browser, click System Configuration to bring up a dialog
box for system 2.
b Select the conveyor in the hierarchical tree. The BaseFrame property
list for the conveyor is now displayed.
c Select the option Use Current Station Values to update the baseframe
value of the robot in the controller.
d Deselect the option Check BaseFrame on Startup.
e In the System Configuration window, click OK. When asked if you
want to restart the system, answer Yes.
NOTE! By deselecting the option Check BaseFrame on Startup, RobotStudio
will not compare the BaseFrame values in the station and the controller every
time the controller is started. This avoids repositioning the conveyor library.
NOTE! If the two robot systems use the same part on the conveyor, the
relation between the part and the two conveyor workobjects should be the
same.
78
3HAC032104-001 Revision: G
© Copyright 2008-2011 ABB. All rights reserved.