1
Download Mobotix MxControlCenter software
Transcript
60/396 MxCC User Manual: System Installation and Initial Operation • Use SHIFT-click to select a range of cameras. Note If one or more of the selected cameras are not directly accessible (i.e., on a different logical network), MxControlCenter automatically offers to reconfigure these cameras (see «Reconfiguring Cameras on Different Logical Networks» below) Reconfiguring Cameras on Different Logical Networks If one or more of the selected MOBOTIX cameras have the status Different subnet (e.g. cameras with factory IP addresses), MxControlCenter automatically offers to reconfigure the network settings of these cameras. In this case, the application will display the dialog shown at the right. Click on Yes to reconfigure the cameras for the subnet of your computer. In most networks, a DHCP server automatically assigns the IP addresses for network devices so you can apply the default settings in the Configure Selected Cameras dialog box (Get IP address automatically). If the IP addresses for devices on the network are manually assigned, ask your network administrator for an IP address range (start and end addresses), a subnet mask and a default gateway. Once you have obtained this information, do the following: • Activate the Use the following IP address (range) option. • IP address (start): Enter the first address of the range. • IP address (end): Enter the last address of the range (this field is only active if you had selected more than one camera in the Add Video Sources dialog). • Subnet mask: Enter the subnet mask. • Default gateway: Enter the IP address of the default gateway. Now wait until MxControlCenter modifies the network settings of the cameras and restarts them. The status of the reconfigured cameras changes from Different subnet (yellow dot) to OK (green dot). © MOBOTIX AG • Security-Vision-Systems • Made in Germany www.mobotix.com • [email protected]
