Download CLS User's Guide

Transcript
Setup
Heat or Cool Control PB
This menu allows you to set the Proportional Band (also known as
Gain).
LOOP
PROCESS
UNITS
02 HEAT CONTROL
PB?
50 ºF
ALARM SETPOINT
STATUS
OUT%
NOTE
The CLS internally represents the proportional band (PB)
as a gain value. When you edit the PB, you'll see the values
change in predefined steps--small steps for narrow PB values and large steps for wide PB values.
The controller calculates the default PB for each input type according to
the following equation:
(High Range - Low Range)
Default PB =
Gain
Heat or Cool Control TI
This menu lets you set the Integral term, or Reset.
LOOP
PROCESS
UNITS
02 HEAT CONTROL
TI ? 180 Sec/R
ALARM SETPOINT
STATUS
OUT%
Selectable range: 0 (off) - 6000 seconds.
Heat or Cool Control TD
This menu lets you set the derivative constant.
LOOP
PROCESS
UNITS
03 HEAT CONTROL
TD ?
0 sec
ALARM SETPOINT
STATUS
OUT%
Selectable range: 0-255 seconds.
CLS User’s Guide 79