Download DataCard ImageCard Select User`s guide
Transcript
6-3 Before you install Selecting the site After meeting general requirements, the site for the Select printer should meet the electrical, physical, and environmental requirements of the printer. Environmental requirements The Select printer requires the following environmental conditions for optimal operation: • Operating relative humidity: 20% to 80% non-condensing • Operating temperature range: 55° F to 95° F (13° C to 35° C) i The maximum operating temperature might be different from the recommended storage temperature. If you store the Select printer, provide an environment with the following conditions: • Storage relative humidity: 20% to 80% non-condensing • Storage temperature range: 0° F to 100° F (-17.8° C to 37.8° C) Remove all supplies from the printer before storing. Electrical requirements The Select printer requires the following electrical conditions for optimal performance: • 100-230 VAC (+/- 10%) at 50/60 Hz (The Select printer automatically adjusts to any power within this range.) • Single phase, 3-wire grounded receptacle only The rated input current for the Select printer is 1.4 amps at 100 VAC applied. Physical requirements The Select printer requires an environment that accommodates its physical dimensions and weight. The printer weighs between 21 and 26.5 pounds or 9.7 and 11.9 kilograms. i The surface holding the printer might also need to bear the weight of other equipment such as a PC and camera. The dimensions are: • Depth of 17.8 inches (54.1 cm) for Select models without duplex or smart card modules • Depth of 24 inches (65 cm) for Select models with duplex or smart card modules • Width of 8.8 inches (22.2 cm) • Height of 10 inches (25.4 cm) Do not block the back air vents or fan opening on the Select printer. User’s Guide for Select™ Platinum Series™ Printers