Download Axis 7100 Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Tilted Spindle Parameters
Tilted Spindle Parameters
Table A-28 lists the parameters in the Tilted Spindle category.
Table A-28: Tilted Spindle Parameters
Category
Parameter
Description
Tilted Spindle
Tilted Spindle
Angle
Defines the Spindle tilt angle value.
Options: 0 - 15 degrees. Default = 2
Tilted Spindle
Y-Offset After
Height
Defines if the System is to perform Y-Offset after
every Height procedure.
Options: Yes; No (Default)
Wash Pipe Parameters
Table A-29 lists the parameters in the Wash Pipe category.
Table A-29: Wash Pipe Parameters
Category
Parameter
Description
Wash Pipe
Activate
Defines whether the wash pipe is active or not.
Options: Yes; No (Default)
Wash Pipe
Display time
defines the time that elapses between displaying the
wash delay message and the activation of the
washing procedure.
Possible Values:
min = 1, max = 1000 (sec), Default = 10
Wash Pipe
Wash Pipe After
Cut
Once set to yes will perform a washing action after the
cut and before the next vision action.
Options: Yes; No (Default)
Wash Pipe After
Cut No.
Number of wash actions after the cut and before the
next vision action.
Possible Values:
min = 1, max = 10 (times), Default = 1
Wash Speed
Defines the X-Axis speed while washing.
Possible Values:
min = 0.01, max = 300 (mm/sec), Default = 10
Washing Start
Delay
Defines the time that passes after the dicing stops
and before the washing procedure is activated.
Possible Values:
min = 6, max = 10000 (sec), Default = 30
Wash Pipe
Wash Pipe
Wash Pipe
P/N 97100-9002-000-14
Ver 06/05
A-47