1
Download - National Instruments
Transcript
Creating a Component Model Using the Model Makers Entering Capacitance data 1. Click the Junction Capacitance Chart tab: To enter Junction Capacitances data: 1. In the databook, find the “Typical Junction Capacitance” chart — for example: Point corresponding to the lowest reveverse voltage Select a second point on the curve in the lower voltage area for the second to lowest reverse voltage. Select a third point on the curve in the lower voltage area for the third to lowest/ second to highest reverse voltage Point corresponding to the highest reverse voltage 2. Find the junction capacitance at zero reverse voltage and enter it in the Junction capacitance at zero reverse voltage (CJO) field. If this information is not given in the databook, enable Check if data not available. Multisim 9 User Guide 8-83
