1
Download onlinecomponents.com
Transcript
INTERBUS Loop 2 The error cause can be determined by measuring the voltages, currents and resistance. For detailed information please refer to "Measuring Procedure"on page 5-10. Compare your measured results with those in Table 5-1 on page 5-14. The measured results provide information on the type of error. m Make sure that all current and voltage measurements are made when the Loop 2 system is under load, i.e., all inputs and outputs must be set. on l in ec om po ne nt s. co Resistance measurements must be carried out when the Loop 2 system is not connected to the power. 5-6 5796C
