Download Logic Pro 9 Control Surfaces Support

Control
Modifier
Assignment
CHAN button on: see Tascam US-2400: Encoder
Details.
CHAN button flashing: encoders control
Instrument parameters. Also see Instrument Edit
View.
PAN button flashing: encoders control plug-in
parameters. Also see Plug-in Edit View.
Other modes: encoders control the parameters of
the active mode.
Encoders
F-KEY
• If you are in Instrument Edit view (CHAN button
flashing), pressing the F-Key enters the
Instrument Assignment view. The encoders are
used to choose an instrument plug-in from the
list (of available software instrument plug-ins).
• If you are in Plug-in Edit view (PAN button
flashing), pressing the F-Key enters the Plug-in
Assignment view. The encoders are used to
choose an effect plug-in from the list (of
available effect plug-ins).
• If you are in Send view (AUX button LED flashes)
and press the F-Key, the encoders are used to
assign the send destination.
SEL buttons
Selects tracks/channels.
SHIFT
In Pan view: sets volume to Unity (0 dB).
In Send views: switches the Send mode (pre/post).
F-KEY
Activates/deactivates Record Enable button of
each channel.
SOLO buttons
Enables/disables Solo.
MUTE buttons
Enables/disables Mute. In Send views with Flip
mode enabled: mutes/unmutes the selected Send.
SHIFT
In Send views: mutes/unmutes the selected Send.
Faders
Controls the volume of each channel (unless
Duplicate or Swap Flip mode is active).
Tascam US-2400: Encoder Details
In CHAN mode (CHAN button on), the encoders control these parameters on the selected
channel:
Control
Assignment
Encoder 1 (AUX 1)
Controls Send 1 level.
Encoder 2 (AUX 2)
Controls Send 2 level.
Encoder 3 (AUX 3)
Controls Send 3 level.
Encoder 4 (AUX 4)
Controls Send 4 level.
Chapter 19 Tascam US-2400
235