Download RH850 Debug - Renesas Electronics

CubeSuite+ V2.02.00
APPENDIX A WINDOW REFERENCE
Set event by stopping
Select whether to forcibly pause the execution for events that cannot be set while executing the
execution momentarily
program or operating the tracer/timer.
For details on the event types that are affected by this property, see "(2) Event types that can be
set and deleted during execution".
Default
No
Modifying
Select from the drop-down list.
Available
Yes
values
Sets these events by stopping the program execution or the tracer/timer
operation momentarily.
No
Does not allow to set these events during program execution or the
tracer/timer operation.
(4) [Break] [Full-spec emulator][E1][E20]
The detailed information on break functions is displayed and its configuration can be changed.
Use software break
Select whether to use the Software break function [Full-spec emulator][E1][E20]Note.
Default
No
Modifying
Select from the drop-down list.
Note that changes can be made only when program execution is halted.
Available
values
First using type of
breakpoint
Yes
Uses the software break function.
No
Does not use the software break function.
Select the type of the breakpoint to use with priority when setting it at the source line or the
execution address with a one click operation of the mouse in the Editor panel/Disassemble
panel.
Default
Software break
Modifying
Select from the drop-down list.
Available
Software break
Sets software breakpoint with priority.
Hardware break
Sets hardware breakpoint with priority.
values
Stop emulation of
Select whether to terminate the peripheral emulation while stopping the program execution
peripherals when
(Peripheral Break).
stopping
Default
No
Modifying
Select from the drop-down list.
Available
Yes
Terminates the peripheral emulation.
No
Does not terminate the peripheral emulation.
values
Note If this property is set to [No] after you have used the software break function, all software break events and
Printf events that have been set will be disabled. Selecting [Yes] in this state does not automatically restore
the events, so you will need to manually enable them.
(5) [Trace]
The detailed information on trace functions is displayed and its configuration can be changed (see "2.12.1
Configure the trace operation").
Cautions 1.
[Full-spec emulator][E1][E20]
Properties in this category cannot be changed during program execution.
R20UT2866EJ0100 Rev.1.00
Feb 01, 2014
Page 170 of 353