Download HYDRAULIC FAN CONTROLLER
Transcript
Table 2: Honeywell NTC Thermistor Temperature vs. Output (Resistance) Table Temp [Deg C] Resistance [ohms] Temp [Deg C] Resistance [ohms] Temp [Deg C] Resistance [ohms] Temp [Deg C] Resistance [ohms] 20 1249.5 45 436.6 70 175.2 95 78.8 21 1194.5 46 420.0 71 169.3 96 76.5 22 1142.1 47 404.0 72 163.7 97 74.3 23 1092.3 48 388.6 73 158.3 98 72.1 24 1045.0 49 374.0 74 153.1 99 70.0 25 1000.0 50 360.0 75 148.1 100 68.0 26 957.2 51 346.6 76 143.3 101 66.0 27 916.4 52 333.8 77 138.6 102 64.2 28 877.6 53 321.5 78 134.1 103 62.3 29 840.7 54 309.7 79 129.8 104 60.6 30 805.5 55 298.4 80 125.7 105 58.9 31 772.0 56 287.6 81 121.7 106 57.2 32 740.0 57 277.3 82 117.9 107 55.6 33 709.6 58 267.3 83 114.2 108 54.1 34 680.6 59 257.8 84 110.6 109 52.6 35 652.8 60 248.7 85 107.2 110 51.2 36 626.5 61 239.9 86 103.8 111 49.8 37 601.3 62 231.5 87 100.6 112 48.4 38 577.2 63 223.4 88 97.6 113 47.1 39 554.3 64 215.7 89 94.6 114 45.8 40 532.3 65 208.2 90 91.7 115 44.6 41 511.4 66 201.1 91 89.0 116 43.4 42 491.4 67 194.2 92 86.3 117 42.3 43 472.3 68 187.6 93 83.7 118 41.1 44 545.0 69 181.3 94 81.2 119 40.1 120 39.0 Note: The table only applies between 20˚C to 120˚C. Temperatures below this range are set to 20˚C, and temperatures above this range are set to 120˚C. Output Specifications Maximum Current Output (High frequency PWM output) Reference Voltage Output Current Adjustments Superimposed Dither Ramp Rate TDAX021500 High side driver 1 output (up to 2A) Solenoid A: 1 proportional or 1 on/off Overcurrent protection is provided Short circuit protection is provided. +5V, 50 mA I-max. (specified by user – configurable setpoint in software) I-set (specified by user – configurable setpoint in software) I-min. (specified by user – configurable setpoint in software) All current settings are adjustable from 0 to 2 Amps. Dither Amplitude: 10% I-max. (fixed) Dither Frequency: (specified by user – configurable setpoint in software) Adjustable from 700-350 Hz Ramps to I-set: (specified by user – configurable setpoint in software) Adjustable from 0-5 seconds. 3