Download R&S RTM2 User Manual

R&S®RTM2000
Remote Control
Command Reference
CHANnel<m>:THReshold:FINDlevel
Executes the analysis of all analog channels that are configured for the selected bus
and sets the threshold for digitization of analog signals for each channel.
16.2.13.4
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Usage:
Event
I²C
The Inter-Integrated Circuit is a simple, lowbandwidth, low-speed protocol used for
communication between on-board devices, for example, in LCD and LED drivers,
RAM, EEPROM, and others.
Note: SPI/SSPI and UART protocols occupy two bus lines (bus 1 and 2 or bus 3 and
4). If one of these buses is configured, the number of buses (suffix <b>) is reduced.
Bus 2 and/or bus 4 is not available.
●
●
●
I²C - Configuration.................................................................................................429
I²C - Trigger...........................................................................................................430
I²C - Decode Results.............................................................................................434
I²C - Configuration
BUS<b>:I2C:CLOCk:SOURce.........................................................................................429
BUS<b>:I2C:DATA:SOURce...........................................................................................429
CHANnel<m>:THReshold:FINDlevel................................................................................ 430
BUS<b>:I2C:CLOCk:SOURce <Source>
Sets the input channel to which the clock line is connected.
Suffix:
<b>
Parameters:
<Source>
.
1..4
Selects the bus.
CH1 | CH2 | CH3 | CH4 | D0..D15
CH3 and CH4 are only available with 4-channel R&S RTM oscilloscopes.
*RST:
CH1
BUS<b>:I2C:DATA:SOURce <Source>
Sets the input channel to which the data line is connected.
Suffix:
<b>
User Manual 1317.4726.02 ─ 02
.
1..4
Selects the bus.
429