Download the GLM System Manual
Transcript
lizes built-in test signal generators inside all Genelec DSP loudspeakers to acoustically measure and align the loudspeaker system. Group Loudspeakers or audio channels designated to play simultaneously. Genelec AutoPhase Genelec AutoPhase is a part of Genelec AutoCal. It aligns the phase of the subwoofer(s) in the system to the designated loudspeaker(s). ID Tone A built-in tone in the DSP loudspeakers and subwoofers used to identify which loudspeaker is being communicated to. GLM AutoLink A user-definable program that allows operators to launch GLM with a specific Setup automatically loaded. GLM Control Network The GLM loudspeaker control network is a proprietary network allowing the setting, reading and monitoring of loudspeakers and subwoofers on the GLM network. System setup can be achieved very rapidly by simply opening a System Setup file, which causes all system and loudspeaker settings to be automatically communicated to all loudspeakers. GLM DSP Loudspeaker Manager Package The GLM control network delivery package containing all hardware and software to build a GLM Loudspeaker Manager environment. Loudspeakers and subwoofers are purchased separately. GLM DSP Multiroom Expansion Package An expansion package providing a license and hardware to install the GLM in multiple rooms within a single facility. GLM Main Page The face of the GLM. This page is used to access all other functions of Loudspeaker Manager. GLM Network Interface The GLM Network Interface is a USB device that connects the computer to the GLM loudspeaker control network. The GLM Network Interface translates communication between the computer and the control network, enabling a very large and physically long control network with multiple loudspeakers. The GLM Network Interface isolates the private and confidential messaging with loudspeakers from any public data networks and from the functioning of the computer running the GLM software. The GLM Network Interface also incorporates a built-in microphone pre-amplifier as well as a high quality soundcard for use during the AutoCal procedure. GLM System Setup Editor This page is used to access more detailed sections of the GLM including the Acoustical Settings Editor. GLM Software GLM is an abbreviation for the Genelec Loudspeaker Manager. This software enables setup and control of loudspeakers on the GLM control network through the use of system setup files, and supports fully automated loudspeaker system setup. IEC Mains Cable A standard detachable mains cable used to apply mains electrical power to the loudspeaker or subwoofer. Interactive Response Editor Located in the Acoustical Settings Editor, this Editor allows for the interactive adjustment of a measured response using the Room Response Controls. Loudspeaker This term is used for loudspeakers that are not subwoofers. A 8240A or 8250A two-way active DSP loudspeaker. Manual Acoustic Wizard A self-guided Wizard that allows for manual calibration of the loudspeaker acoustic parameters. Manual Cabling Wizard A self-guided Wizard that allows for more complicated and versatile System Setups not found in the Rapid Cabling Wizard. Manual Controls The user interface settings on a loudspeaker or subwoofer used when in stand-alone mode. Microphone Holder The rubber mounting hardware to attach the Genelec 8200A Calibration Microphone to a standard microphone stand. MultiPoint A method of spatial averaging used in AutoCal measurements, used when optimizing the Acoustical Settings. Network Cable A CAT5 cable with RJ45 connectors (type PC-to-HUB, straight not crossed wiring). This cable is also used as an Ethernet network cable. Network cables connects the GLM Network Interface to the loudspeakers and subwoofers to form a network of devices that may be controlled using the GLM software Network Control Mode The use of Genelec DSP loudspeakers with the GLM software and the control network. Node Every loudspeaker and the GLM Network Interface is a node on the GLM control network. 9