Download USBCNC manual
Transcript
EDINGCNC Manual Parameter number 5398 5399 5401 5501 5601 5701 – – – – 5499 5599 5699 5799 Meaning always runs until the given end point which may give incorrect tool measurement results. Always take care that the tool table contains (approx.) correct tool data Return value for dlgmsg (+1 OK, -1 Cancel) Return value for M55, M56 Tool z offset (Length) Tool 1 – Tool 99 Tool diameter Tool 1 – Tool 99 Tool x offset (for Turning) Tool 1 – Tool 99 Tool orientation (for Turning) Tool 1 – Tool 99 (Currently supported only Tool 0 .. Tool 99) Tool data Tool ID zOffset (Length) xOffset (For turning) Diameter 1 2 .. 99 orientation 1-9 1-9 .. 1-9 3.1.2.1 TOOL ORIENTATION FOR LATHES When the G18 plane (X-Z) is selected, special LATHE tool radius compensation can be used (G41, G42). Depending on the tool orientation and tool radius an extra offset is applied. The blue crosses show the radius center of the tool. 12 September 2014 Release 4.01 100